58 Service Modes
Manual allowsyou to turn the Service Mode ON and OFF at any
time from a Control telephone. The Service Modes feature code
must be entered at t telephone to access this feature.
Automatic allows you to pre-assign a stop and start time during
which the Service Mode is active. You are still able to start and
stop the Service Mode by entering the Service Modes feature
code at a Control telephone. If you select this setting, you will
have to program start and stop times. See the section in this
chapter on Time and Date for information on
times.
OFF prevents the
Mode from being activated.
Programming hints
Overlapping times may be assigned. For example, if Service
1 is assigned from 9:00 am to 4:00 pm and Service
Mode 2 is assigned from 1:00 pm to
pm, then the Start time
of the second Service Mode is treated as a stop time for the first
Service Mode. This is also true if two Service Modes have the
same start time but different stop times.
If one Service Mode starts and stops within the times of another
Mode, the first service temporarily ends when the second
service starts. The first service then resumes when the second
service has ended.
Default stop and start times correspond to typical hours which
may be required for a night Service Mode.
D e f a u l t S e r v i c e M o d e t i m e s
Service Mode
S t a r t t i m e
S t o p t i m e
S e r v i c e M o d e 1 :
S e r v i c e M o d e 2 : E v e n i n g
Service Mode 3: Lunch
Modular DR5.1 System Coordinator Guide
P O 6 4 2 6 4 7 0 2
Trunk Answer
Service
59
I
Trunk Answer allows you to answer, from any telephone, an
call which is ringing at another telephone in your office.
This
if the other telephones have not been assigned the
same
as the telephone you are using to answer the call.
You can change the Trunk Answer setting only if the Service
Mode is set to Manual or Automatic.
Use the
display button to select the setting: Y (Yes) or
N (No).
Extra-Dial telephone
A telephone normally in service as a Direct-Dial telephone, can
be programmed in Service Modes to allow internal calls to thd
Direct-Dial telephone to also ring at the Extra-Dial telephone.,
Use the
display button and the dial pad to enter the
i n t e r n a l t e l e p h o n e n u m b e r o f t h e E x t r a - D i a l t e l e p h o n e .
hints
.
The Extra-dial telephone provides the option of assigning one
more Direct-Dial telephone in the
system for each
o p e r a t i o n a l S e r v i c e M o d e .
Ringing
You can assign additional telephones to ring for incoming
on each external line, including target lines. Use the
button, the
display button and the dial pad to enter the,
internal telephone number of the Flinging telephone for
Y o u c
rings.
the Auxiliary Ringer (if installed) also
se the
display button to select the setting: Y (Yes)
or N (No).
Programming hints
T h e d e f a u l t r i n g i n g t e l e p h o n e i s 2 2 1 . T h i s m e a n s t h a t a l l l i n e s
ring at Control telephone 221, when Service Modes are
activated. A Ringing telephone can be assigned to more than
one Service Mode.
PO64264702
Modular
System Coordinator Guide
