174
Telephones
The CAP module displays the busy/not busy status of the
telephones in your system by using the triangular indicators
beside Internal Autodial, Programmed Feature or line buttons. A
CAP can support
lines.
You can send up to
messages from ,a CAP.
For more information, see the
Central Answering Position
User Card.
Control telephone
The Control telephone lets you place the external lines for which
it has responsibility into agd out of Service Modes. See Service
M o d e s .
Direct-dial telephone
Y o u c a n d i a l a D i r e c t - d i a l t e l e p h o n e w i t h a s i n g l e d i g i t . T h e
Direct-dial telephone is usually in a central location, such as a
receptionists or secretary’s desk. It is usually a Prime telephone
and a Central Answering Position (CAP).
There may be up to five Direct-dial telephones in your system,
but each telephone in the system is assigned to a single
Direct-dial telephone. There is a single Direct-dial digit for the
whole system that lets each telephone call its assigned
D i r e c t - d i a l t e l e p h o n e .
Each
Direct-dial telephone can send up to 30 messages
and each can invoke Service Modes to activate the Extra-dial
t e l e p h o n e .
Your Installer sets up Direct-dial telephones in Configuration
programming. The System Coordinator assigns telephones to
D i r e c t - d i a l t e l e p h o n e ?
p r o g r a m m i n g .
Emergency telephone
The Emergency telephone is a single-line telephone (not a
telephone) that functions independently of the
system. You can use the Emergency telephone when your
system is not working.
Modular DR5.1 System Coordinator Guide
P O 6 4 2 6 4 7 0 2
S p e c i a l T e l e p h o n e s
Emergency Transfer/Power Failure Cut-through provides
telephone service on external line 001 through an
telephone if the power fails or if a system error occurs.
The Emergency telephone is usually located near the Key
Unit
can
two Emergency
telephones, and each Trunk Module can support one additional
t e l e p h o n e .
Extra-dial telephone
In Service Modes, a second telephone can be assigned to
on calls made to a Direct-dial telephone. There may be one
Extra-dial telephone for each Direct-dial telephone, and it may be
a‘different telephone in each Service Mode.
Hotline telephone
Y o u c a n c a l l a p r o g r a m m e d i n t e r n a l o r e x t e r n a l t e l e p h o n e
number simply by picking up the receiver of the Hotline
(or by pressing
A Hotline telephone can be set up to dial an operator or an
emergency number. You should put a notice by the Hotline
telephone to let people know which
will be dialed when
t h e y l i f t
If the Hotline telephone is set up to dial an external number using
the Prime line, there must be an external Prime line assigned to
t h e t e l e p h o n e . I f n o t , t h e H o t l i n e c a l l w i l l f a i t .
The System Coordinator sets up the Hotline telephone, the
telephone number it dials, and the line on which that number is”
d i a l e d , i n A d m i n i s t r a t i o n p r o g r a m m i n g .
PO64264702
Modular DR5.1 System Coordinator Guide
To
a Hotline
Press
button, or use the Pre-Dial or Automatic Dial feature
before you
up the receiver or press
