Registering individual portables / 83
P0941568 01
Modular ICS 5.0 Companion Installer Guide
3. Press
ñ
or
L
.
4. Press
¡¥»»
.
5. Enter the five-digit ID code for the base station radio you
want to measure. The portable displays this ID followed by
the signal strength, for example
03142 - 54
. Hand-off
does not occur as you move between the cell boundaries.
The link drops when you move out of range.
In this example, the module is
03
, the port is
14
, and the
radio is
2
. The signal strength measured by the base station
is
-54
dBm.
6. To end the connection, press
«
,
e
or close the flap.
Registering the C3020 (Canada only)
The following section describes the procedures involved in
registering Companion C3020 portable telephones. To register
each portable with the Norstar system, you must do two things:
•
Register the portables by entering the Registration
password on each one.
•
Verify that the portable functions properly.
To register the C3020
1. On the Administration set, turn on registration in a general
programming session.
2. On the portable, press
s
, then press
m
.
3. Press
o
.
4. Check the portable display.
If the portable has space for another system, the display
shows
Office n: Free
.
