MM571W / MM572W Installation Instructions
2
BEFORE YOU BEGIN TO INSTALL YOUR AUTOMATIC GATE OPERATOR:
Read these instructions carefully to become familiar with all parts and installation steps.
The video is only designed as an overview of the installation procedure.
You must read the installation manual for detailed instructions
on gate operator safety and proper use of the gate operator.
Please Read This First!
Thank you for purchasing a Mighty Mule Gate Operator—
Nortek Security & Control's "do-it-yourself" automatic
gate operator! When correctly installed and properly used,
your Mighty Mule Gate Operator will give you many years
of reliable service. Please read the following information
to ensure you have the correct system for your particular
needs. If so, this manual and will enable you to properly
install your Mighty Mule Gate Operator.
The Mighty Mule Gate Operator is designed for installation
for single or dual gates. The gate(s) must not exceed 18
feet in length or weigh more than 850 pounds (please see
Technical Specifications on page 10). The Mighty Mule
Gate Operator can be used on vinyl, aluminum, chain link,
farm tube, and wrought iron gates.
Not rated for use on solid surface gates due to the
potential to damage the operator and/or injure someone.
The Mighty Mule Gate Operator accommodates extra
transmitters, digital keypads, solar panels, push buttons,
automatic gate locks, and other access control products.
These optional accessories (see the Mighty Mule
Accessory Catalog) are available at most stores. Your
store should be able to special order any accessory not in
stock.
If your store cannot special order accessories, please call
the Mighty Mule Sales Department (800-421-1587).
The Mighty Mule Gate Operator features Dual Sense
Technology™. This feature makes the gate stop and
reverse direction when it comes in contact with an
obstruction.
The Mighty Mule Gate Operator also has an adjustable
auto-close feature. After the gate reaches the fully open
position, it can be set to remain open up to 120 seconds
before automatically closing. Pressing the transmitter
button at any time after the gate opens fully will cause it
to close immediately. OFF is the factory setting; meaning
the gate will stay open until you press the transmitter (or
keypad, etc.) again.
Go to www.linearproaccess.com for a dealer or retailer
near you or call 800-421-1587 for information about our
Linear professional line of gate operators and accessories.
Our Sales Department will be glad to give you the name
and phone number of a Linear dealer near you.
NOT FOR THE CONTAINMENT OF ANIMALS.
