WebUI navigation
63
•
Link Port Priority—Defines the priority used for this port in the Spanning
Tree Protocol. If the path cost for all ports on a switch are the same, the
port with the highest priority (that is, lowest value) is configured as an
active link in the spanning tree. This makes a port with higher priority
less likely to be blocked if the Spanning Tree Protocol is detecting
network loops. Where more than one port is assigned the highest
priority, the port with lowest numeric identifier is enabled.
— Default: 128
— Range: 0-240, in steps of 16
AP management
The Web and SNMP management interfaces are enabled and open to all
IP addresses by default. To provide more security for management access
to the access point, specific interfaces can be disabled and management
restricted to a single IP address or a limited range of IP addresses.
After you specify an IP address or range of addresses, access to
management interfaces is restricted to the specified addresses. If anyone
tries to access a management interface from an unauthorized address, the
access point rejects the connection.
AP management
UI Management—Enables or disables management access through the
Web (HTTP), or SNMP interfaces. (Default: Enabled)
IP Management—Restricts management access to Web and SNMP
interfaces to specified IP addresses. (Default: Any IP)
•
Any IP: Indicates that any IP address is allowed management access.
•
Single IP: Specifies a single IP address that is allowed management
access.
BAP120
Using the Nortel Business Access Point 120
NN47921-301
01.01
Standard
1.0
August 2006
Copyright © 2006, Nortel Networks
Nortel Networks Confidential
.
Summary of Contents for 120
Page 1: ...BAP120 Using the Nortel Business Access Point 120 NN47921 301 ...
Page 129: ......
