Nortel Switched Firewall 2.3.3 User’s Guide and Command Reference
Layer 2 and Layer 3 Firewalls
195
213455-L, October 2005
Configuring the Check Point software to support Layer 2
bridge mode
Use the following procedure to configure the Check Point software to support Layer 2 bridge
mode.
1.
To configure the cluster to include Switched Firewall
,
NSF#1 and Switched Firewall,
NSF#2, perform the following steps:
1a) Select
General Properties
from the Gateway Cluster Properties menu.
The Gateway Cluster Properties—General Properties page appears (see
Figure 97
).
Figure 97
Gateway Cluster Properties
1b) Type the cluster name in the Name field.
1c) Type the cluster IP address in the IP Address field.
TIP
: Click
Get address
to get the address associated with the name typed in
Step 1b
.
1d) Select
NGX R60
from the version list.
1e) Select your operating system from the OS list.
1f) Select the installation type from the Type list.
