Nortel Switched Firewall 2.3.3 User’s Guide and Command Reference
210
Layer 2 and Layer 3 Firewalls
213455-L, October 2005
7.
To configure synchronization network, perform the following steps.
7a) From the Gateway Cluster Properties menu, select
3rd Party Configuration
.
The 3rd Party Configuration page appears (see
Figure 109
).
7b) In the Specify Cluster operating mode section, select
High Availability
.
7c) Select
Other OPSEC
from the 3rd Party Solution list.
7d) Select
Use State Synchronization
.
7e) Consult the OPSEC documentation to determine the settings for the OPSEC check boxes.
7f) Click
OK
.
N
OTE
–
The configuration menu allows you to create up to 25 bridges. You can add any phys-
ical port other than the SSI management port to these bridges. The bridge ID is the MAC
address of one of the physical interfaces added to the bridge. If the SSI management interface
is configured on a VLAN, the same VLAN cannot be used for any bridge.
Figure 109
Gateway Cluster Properties—3rd Party Configuration
