Nortel Switched Firewall 2.3.3 User’s Guide and Command Reference
Command reference
335
213455-L, October 2005
/cfg/net/vrrp
VRRP Settings Menu
The VRRP Settings Menu is for setting the Virtual Router Redundancy Protocol (VRRP)
parameters for the cluster. Valid addresses must be specified for /cfg/net/vrrp ip1 and
/cfg/net/vrrp ip 2 before changes to the parameter values can be applied (see
VRRP Interface
Menu on page 330
for more information about VRRP). For example configurations, see
Configuring VRRP active-standby failover on page 125
, or
Configuring VRRP active-active
failover on page 145
.
Table 60
VRRP Bridge Menu options (/cfg/net/bridge/vrrp)
Command Syntax and Usage
vrid
<virtual router ID (1-255)>
This command assigns an ID for the virtual router interface. The vrid on this interface
must be configured the same for both the active master and the backup. Separate inter-
faces must have unique vrids.
N
OTE
–
Vrids must be at least one number apart (e.g., vrids 1 and 2 are not acceptable;
vrids 1 and 3 are acceptable).
ip1
<IP address>
This command defines the virtual IP address used to represent Firewall #1 in this virtual
router. The ip1 address must be in the same subnet as the bridge interface IP address
(see
/cfg/net/bridge <bridge number>/addr1 or addr2
on
page 332
).
ip2
<IP address>
This command defines the virtual IP address used to represent Firewall #2 in this virtual
router. The ip2 address must be in the same subnet as the bridge interface IP address
(see
/cfg/net/bridge <bridge number>/addr1 or addr2
on
page 332
).
[VrrpSettings Menu]
ha - Set high availability
aa - Set Active-Active
clusterxl - Set Cluster XL
adint - Set Vrrp Advertisement Interval
garp - Set Garp Delay interval after failover
gbcast - Set Garp broadcast interval
afc - Set Advanced failover check
prefmaster - Set Preferred Master
