Nortel Switched Firewall 2.3.3 User’s Guide and Command Reference
Command reference
345
213455-L, October 2005
retra
<time interval (1-65535)>
This command sets the time interval, in seconds, between each transmission of LSAs to
adjacencies on this interface. The default value is five seconds. This value must be the
same on all routing devices within the area.
auth none
|
password
|
md5
This command sets the authentication type for this interface:
none
turns off OSPF authentication.
password
turns on type 1 (plain text) password authentication. The password is set using
the
key
option.
md5 turns on MD5 (strong encryption) password authentication. The password is defined
using md5key option.
For more information, see
Authentication on page 100
.
key
<type 1 password>
This option is used with the previous OSPF
auth
option. When the
auth
option is set
to
passwor
d, the
key
option sets the password to be used for OSPF authentication on
this IP interface. Specify a type 1 (plain text) password of up to eight characters. To clear
the key, specify none as the value.
md5key
<MD5 key number (1-255)>
<MD5 authentication key>
This option is used to define an MD5 password for OSPF authentication on this IP inter-
face. Specify the key ID number of an MD5 password defined in the above OSPF
auth
md5
key Entry Menu. Assigned passwords are ignored until MD5 authentication is
enabled in the
auth
option.
ena
This command enables this interface.
dis
This command disables this interface.
Table 66
OSPF Interface Menu (/cfg/net/ospf/if>) (Continued)
Command Syntax and Usage
