Nortel Switched Firewall 2.3.3 User’s Guide and Command Reference
Initial setup
41
213455-L, October 2005
11.
Set the new administrator password.
The current default administrator password is admin. Nortel recommends that you change the
password.
12.
Choose whether to enable the Check Point SmartCenter Server on the firewall.
Setup gives you the option of configuring your Nortel Switched Firewall with or without a
collocated SmartCenter Server. Enabling the SmartCenter Server on the Switched Firewall lets
you use the interface without requiring Secure Internal Communications. A second license is
also not required for hosting the SmartCenter Server on the management station. However, you
may not want to take advantage of this feature if you intend to install a second Switched
Firewall in a cluster with this firewall. In that case, you must enter 1 or 3 at the prompt and
install the SmartCenter Server on the management station.
See Check Point documentation for more information about Check Point Express.
N
OTE
–
If you install the SmartCenter Server on the firewall now, but decide later to add a
second Switched Firewall to the cluster (to implement a active-standby (high-availability) or
active-active firewall configuration), you must
reimage
your system and repeat Setup to
uninstall the SmartCenter Server.
13.
If you chose 2 or 4 in
Step 12
, enter the management server administrative password.
Enter a password for the "admin" user:
<password>
Re-enter to confirm:
<password>
Select installation type:
1. Check Point Gateway
2. Check Point Gateway and SmartCenter Server
3. Check Point Express Gateway
4. Check Point Express Gateway and SmartCenter Server
Enter your selection: (1/2/3/4) [1]:
Enter Check Point Primary SmartCenter Server admin password:
<pass-
word>
Re-enter to confirm:
<password>
