Chapter 2 Installing the 8660 SDM
29
Installing the 8660 Service Delivery Module (SDM)
Required tools
You require the following tools to remove or install a chassis filler panel: Phillips
#0 or #1 screwdriver.
Removing a chassis filler panel
To remove a chassis filler panel:
1
Use a Phillips screwdriver to loosen the two captive screws that fasten the
filler panel to the chassis.
shows the captive screws on the 8003,
shows the captive screws on the
8010co chassis.
Figure 5
Removing a filler panel from an 8003, 8006, or 8010 chassis
10249FA