66
Chapter 4 Replacing a PrPMC
217314-B Rev 00
Removing a PrPMC filler panel
To remove a PrPMC filler panel:
1
Use a Phillips screwdriver to remove the two screws that secure the filler
panel to the SDM FW1 or FW2 board (see
Figure 47
Removing the PrPMC filler panel screws
2
Pull the filler panel out of the slot.
Installing a PrPMC filler panel
If you plan to remove a PrPMC without immediately replacing it, you must install
a filler panel in the slot.
To install a PrPMC filler panel:
1
Locate the slot where you must install the filler panel.
2
Place the filler panel over the slot
3
Use a Phillips screwdriver to insert and tighten the two screws that secure the
filler panel to the 8660 SDM faceplate.
11218FA