Chapter 2 Installing the 8660 SDM
31
Installing the 8660 Service Delivery Module (SDM)
Installing and replacing an 8660 SDM
To prevent static discharge damage when you work with 8600 modules, place
each module on a grounded antistatic mat until you are ready to install it. If you do
not have an antistatic mat, wear a discharge leash or wrist strap to free yourself of
static before you touch a module. (An antistatic wrist strap is shipped with the
8010co chassis.) You can also free yourself of static by touching the metal chassis
before you handle the module.
You can add or replace a module with the chassis power on or off.
To replace an 8660 SDM, start with the procedure described in
. To install an 8660 SDM, see
.
Estimated time to install or remove an 8660 SDM
The estimated time to remove an 8660 SDM is 15 minutes.
The estimated time to install an 8660 SDM is 15 minutes.
Required tools
You require the following tools to install or remove an 8660 SDM: Phillips #0 or
#1 screwdriver.
Caution:
The 8660 SDM cards are sensitive to static electricity. Static
discharge from your clothing or other fixtures around you, even at levels
that do not create a spark, can damage hardware. Follow the procedures
in this section to protect your equipment from damage.
