Chapter 4 Replacing a PrPMC
65
Installing the 8660 Service Delivery Module (SDM)
Removing and installing a PrPMC filler panel
Nortel
ships the SDM FW1 and FW2 with a filler panel covering each empty
module slot.
Before you install a new PrPMC, you must remove the appropriate filler panel.
For instructions, see
“Removing a PrPMC filler panel” on page 66
.
To install a filler panel, see
“Installing a PrPMC filler panel” on page 66
Estimated time to remove or install a PrPMC filler panel
The estimated time to remove a PrPMC filler panel is ten minutes.
The estimated time to install a PrPMC filler panel is ten minutes.
Required tools
You require the following tools to replace a PrPMC filler panel: #1 Phillips
screwdriver.