8660 SDM specifications
69
Installing the 8660 Service Delivery Module (SDM)
Management port
The management port is a 10/100/1000Base-T Ethernet port implemented on an
RJ-45 connector wired as an MDI connection.
shows the pin assignments
for this connector.
Console serial port
The console serial port is implemented as a DB-9 connector. This port operates as
a Data Communication Equipment (DCE) device. Default settings for this port are
9600 bits/s, 8 data bits, no parity, and one stop bit.
Connection to TXD and RXD signals and GND is sufficient for the console serial
port to fully function. The console port does not support any inbound flow control
(that is, the port does not toggle control lines to indicate an input buffer full
condition).
Table 5
Pin assignments: 8660 SDM management port
Connector
Pin number
Signal
1
Output transmit data + (TX+)
2
Output transmit data - (TX-)
3
Input receive data + (RX+)
6
Input receive data - (RX-)
4, 5, 7, 8
Not used
12345678
8020EA
