64
Appendix Configuring phantom DNs
2
Enter LD 97.
3
At the REQ prompt, enter CHG.
4
At the TYPE prompt, enter SUPL.
5
At the SUPL prompt, enter xxxx, where xxxx is the loop number,
prefixed with N to designate the loop as a phantom loop, or with V to
designate a virtual loop.
For Large Systems, xxxx = N0–N156 in multiples of 4.
For Small Systems, xxxx = N96 - N112 in multiples of 4.
6
To exit the overlay, enter ****.
—End—
Creating a phantom DN
Step
Action
1
Connect to the PBX.
2
Enter LD 10.
3
Enter the appropriate values as described in the following table
to modify the system parameters. For prompts not listed in the
following table, press Enter to accept the default.
Table 19
LD 10 - Creating a phantom DN
Prompt
Response
Notes
REQ
NEW
TYPE
500
TN
aaa.bbb.ccc.ddd
Terminal number, where aaa =
loop, bbb = shelf, ccc = card,
and ddd = unit.
CDEN
xx
Card density supported by the
loop, where xx = DD for double
density, or 4D for quadruple
density.
DN
xxxx
DN for CallPilot.
Nortel CallPilot
Quickstart Guide
NN44200-313
01.02
Standard
5.0
19 May 2008
Copyright © 2007-2008, Nortel Networks
.
Summary of Contents for CallPilot 5.0
Page 1: ...Nortel CallPilot Quickstart Guide NN44200 313 ...
Page 4: ......
