136
Carrier Remote IPE acceptance testing
Voice calls
A voice call can be established between two voice terminals across a
network, between two terminals on the same PBX, and even between two
terminals on the same line card.
Acceptance testing of Carrier Remote IPE voice calls is conducted when
testing the following basic system features supported by telephones
connected to subscriber loops at the remote site:
•
placing a call to the remote site
•
placing a call in call hold/call retrieve
Placing a call to the remote site
From the local system site, place a call to a Carrier Remote IPE site by
dialing a remote station directory number (extension number).
Note:
The system treats Carrier Remote IPE subscriber loops as local
loops, so it is necessary to dial only the extension number to access
that station.
To perform a call test, follow the steps in
Procedure 31 “Performing a call
.
Procedure 31
Performing a call test
Step
Action
1
From a telephone at the local system site, dial a telephone at the
Carrier Remote IPE site and establish an active call connection.
2
Verify that voice transmission is established by talking with the
person at the other telephone.
Make sure the speech is clear in both directions.
3
Maintain the connection and ask the person at the remote site to
test some basic calling features such as call hold/call retrieve.
4
Terminate the call.
--End--
Call hold/call retrieve
Call hold is used to place an active call on hold in order to answer an
incoming call or place an outgoing call. After releasing an incoming or an
outgoing call, the call on hold can be retrieved. For the Carrier Remote
Nortel Communication Server 1000
Carrier Remote IPE Fundamentals
NN43021-555 04.01
4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
.
Summary of Contents for Communication Server 100
Page 213: ......
