156
Carrier Remote IPE maintenance
Table 28
Keyboard to keypad translation table (cont’d.)
Terminal keyboard
Telephone key pad
M
N
O
6
6
P
R
S
7
7
T
U
V
8
8
W
X
Y
9
9
0
0
Space or #
#
Return
##
To use a diagnostic program on the system. follow the steps in
36 “Using a diagnostic program on the system” (page 156)
Procedure 36
Using a diagnostic program on the system
Step
Action
1
Press the prime DN key.
2
Place the telephone in the maintenance mode by entering
xxxx91
on the keypad, where
xxxx
is the customer’s special
prefix number (SPRE) as defined in LD 15.
Normally xxxx is 1, therefore
191
would be entered.
3
Enter
**
to check if the communication link is idle.
a
If a busy tone is detected, the system is in session with
another maintenance or administration terminal. Enter
****
to force the other terminal to log out.
b If a busy tone is not detected, the system is idle and the
system is automatically accessed.
4
Enter
53#xx##
to load a diagnostic program, where
xx
is the
program number.
For example, to load Network and IPE Diagnostic Program LD
32, enter
53#32##
.
5
Perform the maintenance tasks by executing the maintenance
commands resident in the loaded program.
For example, from Network and IPE Diagnostic Program LD 32,
a network loop can be disabled by executing
DISL loop
, where
loop is the Local Carrier Interface card loop; for example, 3. To
execute this command enter
3475#3##
on the keypad.
Nortel Communication Server 1000
Carrier Remote IPE Fundamentals
NN43021-555 04.01
4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
.
Summary of Contents for Communication Server 100
Page 213: ......
