1-46
Equipment operation
Nortel Networks Confidential
411-2051-500
Draft
00.01
November 1999
Downloading the MCPA firmware to the MCPA shelf (if required)
Note: This procedure is required only if you need to upgrade the MCPA
firmware from version 2.1 to a newer version.
Use the following procedure if you need to download the firmware to the MCPA
shelf:
1. Run the ‘Nortel gain’ program by performing Steps 1 to 5 of the
procedure listed in the Running the MCPA software on the computer
section. The power setting menu will pop out (see Figure 1-11).
2. At the menu, click on the Download parameter and then select the
software version, for example, NTRACK2_2.HEX.
3. At the ‘Powerwave Technologies’ menu, select ‘Download’.
4. At the ‘Warning’ menu, select ‘OK’. The screen will show the following:
5. Midway through the download process, the secreen will turn to the
following:
6. When download is complete, the software will display ‘Download is
complete’ on the screen. Click ‘OK’. The shelf is ready for operation.
IMPORTANT
Power to the MCPA shelf must remain on during the
downloading period.
Summary of Contents for DualMode 800
