70
Chapter 3 Installing the 8010co chassis
316314-E Rev 01
To attach a ground to one of the chassis grounding studs, you need the following:
•
One single-hole cable lug that fits over one of the grounding studs
•
Nut and a locking washer for the grounding stud.
•
6-AWG grounding wire that is long enough to connect to the ground point.
•
7/16-inch hex wrench to fasten the hardware in the correct order.
shows an example of how to ground two 8010co chassis and
a BIP. For this example, each chassis is configured with three 8004DC power
supplies.
describes the reference items shown in
.
Note:
Your rack-grounding strip may look different or may be in a
different location than the one shown in the following example.
Summary of Contents for Passport 8000 Series
