Page 14 of 30
Installing the Saw Blade
Check that the cutter engine is turned off and cooled before attempting any maintenance, cleaning, or
inspection to avoid an accidental start and possible injury.
Note:
The saw blade is not supplied.
Diamond Saw Blade Specifications
Diameter (A): 14-inch
Arbor Hole (B): 25.4mm(1-inch)
Pin Hole (C): 13mm
Center to Center (D): 28.7mm.
Be sure to check the blade's direction of
rotation (01).
DO NOT use a blade that is missing a
segment (02) or is cracked. Damaged
and/or missing segments or cracks may
cause damage to your saw and injury to
the user or others in the operating area.
Figure 1
See Figure 2.
1. Raise the Concrete Cutter by turning the Elevator Handle clockwise.
2. Remove the Hose (03) from the One Touch Fitting (02).
3. Remove Nut (05), and then remove Bolt (04) using a 17mm wrench (not included).
4. Using the handle on the Blade Cover (01) rotate the cover back exposing the saw blade mounting
fixtures.
Figure 2
Summary of Contents for 49157
Page 9: ...Page 9 of 30 13 Elevate Bar...
Page 19: ...Page 19 of 30 Parts Diagram Engine Mount...
Page 21: ...Page 21 of 30 Blade Shaft...
Page 23: ...Page 23 of 30 Adjust Handle...