Page 15 of 30
See Figure 3.
5. Remove Counterclockwise Nut (06) with the supplied 36mm wrench (07). If the shaft spins, hold it
in place with the supplied 32mm wrench (08).
6. Remove the Blade Holder Outer (09).
Figure 3
See Figure 4.
7. Install the Saw Blade (11) on the blade shaft (10) making sure that the pin hole in the Saw Blade
engages the pin of the Blade Holder Inner (12). Make sure that the Saw Blade is installed in the
correct direction of rotation (A).
Figure 4
Summary of Contents for 49157
Page 9: ...Page 9 of 30 13 Elevate Bar...
Page 19: ...Page 19 of 30 Parts Diagram Engine Mount...
Page 21: ...Page 21 of 30 Blade Shaft...
Page 23: ...Page 23 of 30 Adjust Handle...