3. PART 2 - For Users
3.0 PUT IN OPERATION - GENERAL PRECAUTIONS ...................................
We would like to remind you that these appliances are designed exclusively
professional use and must be operated by specialized personnel.
In order to set the crepe machine into operation, observe meticulously
everything include these pages as well as ordinary safety measures:
•
Verify that there are not escapes of gas.
•
Verify the stability of the flames passing from the maximum to the
minimum setting.
•
Check the regular lighting of the main burner.
•
Verify that there is a good influx of fresh air.
Look out for not surfaces on the outside of the appliance
during preparation and grilling. These are clearly marked
with the symbol shown on the right.
After making sure the appliance has been correct
connected to the electricity and gas supplies you can
ignite and start using it.
NORTH APPLIANCES DOES NOT EQUIPPED WITH A
PIEZOELLECTRIC IGNITER IF YOU WANT TO IGNITE
BURNERS YOU NEED TO USE A MATCH OR A LIGHTER
3.0 LIGHTING BURNER – TURN THE MOTOR ON AND LAMP.....................
•
When appliance is off, the gate valve is vertical and the round indication I
top.
•
Push the knob slightly and turn it anti-clockwise until you bring it to the
flame indication.
•
While you keep the handle pressed, light the appliance using a candle.
•
Keep the handle pressed for a few seconds until the thermocouple.
•
Turn the handle anti-clockwise until you bring it to the position of the
highest flame and make sure the burner is turned on completely.
•
The following nick is that of the medium flame; you can choose this setting
once machine has reached the desired temperature.
•
Make the same step to turn on the other entire burner.
•
To turn on the motor in the right side of the machine are the RED switch
on/off the one which are in the bottom are for the lamp inside the machine
the other are for the motor.
