2.3 POSSIBLE PROBLEM… ...… … … … … … … … … … … … … … … … … … … … … … … … … … … … … … …
Even if the appliance is used correctly, some problems may arise for various reasons. The table that
follows mentions some possible problems and some possible causes.
In case of problem we control first if the electrical supply to the machine is right or not.
POSSIBLE PROBLEM
POSSIBLE CAUSES
Machine is not operating
Drop of main voltage.
Heating element is not operating
Check if there is damage to 1)the heating
element 2)the edge of supply cord connected
with heating element. 3) the contactor of switch
4) the switch
Motor is not operating
Check if there is damages to 1)switch on-off
2)the motor coil or gear. 3) fat grouping to the
axis of rotation.
2.3 REPLACEMENT OF ELECTRICAL ELEMENTS.............................................................................
To replace heating elements, switches and indicating lamps remove the rear cover of the appliance.
Release heating elements, switches and indicating lamps and replace.
Remount the rear plate.
CUT OFF THE POWER SUPPLY BEFORE COVER REMOVAL.
2.4 TRAINING.........................................................................................................................................
The personnel who are to install and connect the appliance must train the users appropriately so
that they can handle the operation and safety measures of the appliance.
ATTENTION !!!
•
Check that main voltage in your working area is suitable for the settings on the label and that the
appliance is properly earthed.
•
Before any service activity takes place or any parts are replaced on the appliance, make sure that
pains supply is turned off.
THE MANUFACTURER CANNOT BE HELD RESPONSIBLE FOR ACCIDENTS AND DAMAGE
CAUSED TO PERSONS, ANIMALS OR PROPERTY DUE TO NONCOMPLIANCE WITH THESE
INSTRUCTIONS.
