1
INSTALLING A 4” SPOOL OF WIRE
2
INSTALLING A 8” SPOOL OF WIRE
5
SLIDE MIG GUN INTO WIRE FEEDER
6
TIGHTEN RETAINING SCREW FOR MIG GUN
9
FEED WIRE - CLOSE TENSION ARM
10
FEED WIRE - REMOVE GUN TIP & NOZZLE
Remove wing nut, washer and black bushing. Slide on spool so
wire feeds off the bottom of spool. Reinstall bushing, washer and
wing nut. See Step 13 to adjust wire spool tension.
Remove wing nut, washer and black bushing. Slide on spool
adapter. Reinstall bushing, washer and wing nut. Slide on 8”
spool of wire. Knob on spool adapter slides into hole on side of
8” spool of wire. See Step 13 to adjust wire spool tension.
Remove Retaining Screw (see step 6) Slide the machine end of
the MIG gun into the front panel receptacle. Push it all the way
into the wire feeder as far as it will go. Feed trigger leads through
the opening in the front panel.
Tighten the retaining screw on the wire feeder housing to secure
the gun. Install trigger leads into the trigger lead receptacle.
Close the drive roll tension arm. Apply tension to the wire by
turning the wing nut clockwise on the Drive Roll Tension Adjust-
ment. Do not overtighten. See Step 14.
To finish feeding the wire through the MIG gun, you will need to
remove the gun nozzle and tip.
4 In.
Spool
Wing
Nut
Knob
8 In.
Spool
Adapter
Trigger
Lead
Opening
Retaining
Screw
Trigger
Lead
Recpt.
Tension
Adjustment