13. Avoid unintentional starting.
Be sure the switch is in the Off position when not in
use and before plugging in.
14. Stay alert.
Watch what you are doing, use common sense. Do not operate any tool
when you are tired.
15. Check for damaged parts.
Before using any tool, any part that appears damaged
should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment and binding of moving parts; any broken parts or
mounting fixtures; and any other condition that may affect proper operation. Any part that
is damaged should be properly repaired or replaced by a qualified technician. Do not use
the tool if any switch does not turn On and Off properly.
16. Guard against electric shock.
Prevent body contact with grounded surfaces such
as pipes, radiators, ranges, and refrigerator enclosures.
17. Replacement parts and accessories.
When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use accessories
intended for use with this tool.
18. Do not operate tool if under the influence of alcohol or drugs.
Read warning
labels on prescriptions to determine if your judgment or reflexes are impaired while
taking drugs. If there is any doubt, do not operate the tool.
Unpacking
When unpacking, check to make sure the following parts are included.
Cutting Oil (2.5 litres) Pouch with: 2 Sets of dies, 3 Hex Wrenches
Machine Stand Legs (3) and 1 Screwdriver
Assembly
1. With the unit on its side, insert the four Machine Stand legs into the holes in the
base.
2. Secure with lock bolts provided.
3. Hoist up the unit and place upright on its legs.
4. Please insert the pin into
body (Part 1, pg.9) to
assemble the cutter (Part 6, pg.12)
Page 3 of 12
