Page of 13
8
pointed in the direction of the Drum rotation (clockwise). When
correct
M
ixer (28) position is
found, go ahead to fix it. First, put one
M8x25
Cross Head Bolt (32) from outside of the drum
upper (or lower), and insert one
L
eather
W
asher (29) to the Bolt (32) from inside of the Drum.
Then, put the
M
ixer (28) next to the
L
eather
W
asher (
29
) . Finally, put Flat
W
asher (4) ,Spring
W
asher (7) to the Bolt (32) and fix with the Hex Nut (5)
.
To repeat this procedure, and fix the
other 3 Bolts.
17.
Mount the inner Motor Base Cover (58) to the
Iron Tube Fixture (L.H.)
(37) bearing using two
M8x25
Hex Bolts (9), Flat Washer (4), Spring washers (7) and Hex Nuts (5).
18. Attach the Motor Mount Plate (55) to the inner Motor Base Cover (58) using the Hex. Bolt (46),
Flat Washer (
31
), Spring Washer (34)
,
Hex. Nut (35), and Strap (61). Tighten sufficiently to hold
in place. See photo above.
Note
: Once the Motor (52) is mounted, the Motor Mount Plate must be adjusted up or down to
tighten the Belt (68).
19. Place the Motor (52), attached by power cable to the outer Motor Base Cover (64), on top of the
Motor Mount Plate (55). Refer to the photo on the top of the next page.
20. Secure the Motor to the Motor Mount Plate using
M8x20
Hex. Bolt (56), Flat Washer (4),
Spring
Washer (7)
and Hex. Nut (5). Tighten all four Hex. Nuts hand-tight. The Motor
will be adjusted
forward or backward later.
21. Clean the pinion shaft of all plastic protective material and other debris. Also clean out debris
from Pulley (4
5
) center hole.
22. Squarely push the Pulley center onto the pinion shaft so that the groove in the pulley engages
the Key (
53
). The Pulley should be flush with the step on the pinion shaft.
Cauti o n
: Do not pound the Pulley onto the pinion shaft. Damage can occur causing a loose fit.
