5
P0908433 01
Flash Installation Guide
Mounting the module
You must open the door of the unit before you can mount the module. To
mount the module:
1.
Position the Flash module next to the KSU and hold it against the
plywood backboard.
2.
Install a #10 X 2.5 cm (#10 X 1 in) wood screw in the top screw hole,
but do not tighten it completely.
3.
Make sure the module is level. Install and tighten a wood screw in the
bottom screw hole.
4.
Tighten the top screw to secure the module.
You are now ready to connect the module to the KSU.
Figure 2 Mounting screw holes and connectors
Mounting
screw holes
power supply
connector
teledapt line
jacks
25-pin
connector
Summary of Contents for Flash Basic 2
Page 2: ......