6
Flash Installation Guide
P0908433 01
Figure 3 Installation overview
Connecting the module to the KSU
Before you begin, ensure a Norstar station port is available at the distribution
block and all line appearances are removed from the Flash DN(s) prior to
booting the unit. For instructions on installing a station port and removing
line appearances, refer to the
Norstar Installation Guide
that came with the
Norstar KSU.
To connect the module:
1.
Locate the distribution block.
2.
Ensure there are available station ports at the distribution block. You
need one station port for a two channel Flash and two station ports for
a four channel Flash.
3.
Mount the teladapt jack(s) next to the distribution block.
4.
Use twisted pair station wire to connect each teladapt jack to a free
station port in the distribution block.
5.
Use a working Norstar telephone to test the port(s).
Flash Module
Feature
Norstar Modular KSU
Distribution Block
Cartridge
Power Supply
Summary of Contents for Flash Basic 2
Page 2: ......
