17
P0908433 01
Flash Installation Guide
Determining Flash Feature Codes
The Feature Codes for Flash are 980 through 989 or 904 through 913,
inclusive. When these Feature Codes are used by other Norstar applications,
Norstar assigns Feature Codes between 900 and 999 to Flash. These codes
might not be assigned in sequential order. Record the assigned Feature
Codes on Table 5 below.
Table 5 Assigned Feature Codes
7.
Press
OK
.
To return to Step 3, press
RETRY
.
When the initial configuration is completed,
the display shows
System Ready
and
Exit
.
The display then returns to the Norstar date
and time.
Feature Code name
Number
Used By
*
*VML is Voice Mail Light, VM is Voice Mail, ACD is Automatic Call Distribution.
Leave Message
Feature 9 ____ ____
VML and VM
Open Mailbox
Feature 9 ____ ____
VML, VM and
ACD
Operator/Service Control
Feature 9 ____ ____
VML, VM and
ACD
System Administration
Feature 9 ____ ____
VML, VM and
ACD
Log in/out
Feature 9 ____ ____
ACD only
Flash DN
Feature 9 ____ ____
VML, VM and
ACD
Transfer
Feature 9 ____ ____
VML and VM
Interrupt
Feature 9 ____ ____
VML and VM
Busy Mode
Feature 9 ____ ____
ACD only
Queue Status
Feature 9 ____ ____
ACD only
System∫config
RETRY∫∫∫∫∫∫∫∫∫
Configuring...
Summary of Contents for Flash Basic 2
Page 2: ......