Page 100 of 220 Verifying a Meridian Companion installation
553-3601-200 Standard 7.00 November 1998
Figure 31 : Floor plan with transcribed information
Note 1: The cell boundary value should be a high-power measurement. An
H
on the portable’s display indicates the portable is transmitting in
high-power mode (an
L
indicates low-power mode).
Note 2: RSSI measurements are displayed as negative values. The smaller
the negative value the stronger the signal strength. For example, a
signal strength of
-60
dBm is stronger than one of
-73
dBm.
If a significant area within the coverage area has an RSSI signal
strength less than the cell boundary value, refer to Meridian
Companion Site Planning Reference Manual to redeploy cell centers
in the impacted area to fill the gap, or add an additional cell center if
necessary.
cell center
❍
cell number
❏
Base Station port number
❍
❍
02
❏
❏
0106,
0113
14
0115,
0122
❍
09
❏
0104,
0118
❍
36
❏
0127,
0131
❍
57
❏
0102,
0109
❍
35
❏
0124,
0129
❍
64
❏
0107,
0120
Summary of Contents for Meridian 1 PC Console Interface Unit
