Programming the Meridian Companion system Page 77 of 220
Meridian Companion Installation and Maintenance Guide
Note:
You can also enter an Administration session using the
Configuration password. Once you complete steps 1 and 2 in
“Entering a Configuration programming session” on page 76,
press
*
then
^
. The display shows
1. Registration
.
Ending a programming session
To end Configuration programming or an Administration session, press
®
. The display shows
End of session
.
Recording and reporting alarm messages
Alarm messages appear on the display of the Administration Terminal when
the Meridian Companion system generates an alarm. Your Meridian
Companion supplier can interpret these messages to detect problems affecting
system operation. The Administration Terminal must be connected to port 00
on the Controller to receive alarm messages.
This is an example of an alarm message:
See Table 42 on page 183 for other alarm messages.
If an alarm message appears on the Administration Terminal’s
display
1.
Record the alarm message in Meridian Companion Programming and
Provisioning Record.
2.
Press
TIME
and record the time and date displayed.
3.
Press
CLEAR
to clear the alarm.
4.
Call the system support representative to report the alarm message.
Alarm:
TIME
51-3
CLEAR
Summary of Contents for Meridian 1 PC Console Interface Unit
