DAYLIGHT SAVINGS TIME:
· Always keep the DST button located on the back of the clock in the ON position. Residents in the
states of Arizona and Indiana that do not switch to Daylight Savings Time should keep in the
OFF position.
RESET:
· If your clock is not receiving the signal and you need to reset you may remove the battery and re-
install or replace if battery is weak or dead. The hands will spin and stop at the 12 o’clock
position while the clock searches for the signal again.
TO IMPROVE THE RADIO SIGNAL RECEPTION
:
•
Do not place the clock too close to household appliances such as televisions, computers,
speakers, DVD players, VCR’s, fax machines or similar items.
•
Do not place on top of or close to metal surfaces.
•
Do not place in a metal or concrete building unless close to a window with the curtains or
other window treatment open.
•
Do not use inside of a moving vehicle.
RADIO SIGNAL RECEPTION MAY BE BLOCKED BY THE FOLLOWING CONDITIONS:
•
Mountains and valleys
•
Tall buildings
•
Power plants, power lines or high voltage cables
•
Freeways and Airports
•
Construction Sites
•
Traffic Lights
•
Neon Lights
•
Cement or Metal Walls
•
Bad weather between your location and the radio transmitter in Colorado
•
If you find your signal is blocked try moving to a new location.
CARE OF YOUR CLOCK
:
•
Replace the battery annually or whenever the clock looses its ability to sense the radio signal
while in its normal place in your home or office. Store the clock without a battery when not in
use.
•
A soft dry cloth or a paper towel may be used to clean your clock. Do not use any corrosive
cleanser or chemical solutions on the clock. Keep the clock clean and dry to avoid any
problems.