User Manual of Network Camera
53
The IEEE 802.1X standard is supported by the network cameras, and when the feature
is enabled, the camera data is secured and user authentication is needed when
connecting the camera to the network protected by the IEEE 802.1X.
Before you start:
The authentication server must be configured. Please apply and register a user name
and password for 802.1X in the server.
For your privacy and to better protect your system against security risks, we
strongly recommend the use of strong passwords for all functions and network
devices. The password should be something of your own choosing (using a
minimum of 8 characters, including at least three of the following categories:
upper case letters, lower case letters, numbers and special characters) in order to
increase the security of your product.
Proper configuration of all passwords and other security settings is the
responsibility of the installer and/or end-user.
Steps:
1.
Enter the 802.1X Settings interface:
Configuration >
Advanced Configuration >
Network > 802.1X
Figure 6-15
802.1X Settings
2.
Check the
Enable IEEE 802.1X
checkbox to enable the feature.
3.
Configure the 802.1X settings, including EAPOL version, user name and
password.
Note:
The EAPOL version must be identical with that of the router or the switch.
Summary of Contents for NTH-IP3B
Page 1: ......
Page 139: ...User Manual of Network Camera 139 Figure A 1 2 Modify Network Parameters ...
Page 142: ......
