User Manual of Network Camera
55
implementation of networks in the home and corporate environments.
With the function enabled, you don’t need to configure the port mapping for each port,
and the camera is connected to the Wide Area Network via the router.
Steps:
1.
Enter the UPnP™ settings interface.
Configuration >Advanced Configuration >
Network > UPnP
2.
Check the checkbox to enable the UPnP™ function.
The name of the device when detected online can be edited.
Figure 6-17
UPnP Settings
6.3.9
Configuring Wireless Dial Settings
Purpose:
Data stream of audio, video and image can be transferred via 3G / 4G wireless
network.
Note:
The wireless dial function requires the support of the camera.
1.
Click the
Wireless Dial
tab to enter the Wireless Dial configuration interface.
2.
Check the checkbox of
Enable
to enable the wireless dial settings.
3.
Configure the dial parameters.
1)
Select the dial mode from the drop-down list. Auto and Manual are selectable.
If Auto is selected, you can set the arming schedule for dialing; If Manual is
selected, you can set the offline time and manual dialing parameters.
2)
Set the access number, user name, password, APN, MTU and verification
protocol. You can also leave these parameters blank, and the device will
adopt the default settings for dialing after other parameters are configured.
3)
Select the network mode from the drop-down list. Auto, 3G and 4G are
selectable. If Auto is selected, the network selection priority comes as: 4G >
Summary of Contents for NTH-IP3B
Page 1: ......
Page 139: ...User Manual of Network Camera 139 Figure A 1 2 Modify Network Parameters ...
Page 142: ......
