SECTION FOUR: Networking the Northstar 6000i
Page 20
6000i
Installation Manual, Rev. G
Ethernet cables
After determining the need for waterproofing and the type of cable required as described above,
select the specific cables needed:
•
waterproof or not (for each end)
•
crossover or straight through
•
both connectors installed, or one connector not installed for threading through a wiring
tube or bulkhead hole
The maximum cable length between any two devices should not exceed 100 meters.
Using store-bought cables
Non-waterproof cables obtained a local computer store can be used in the situations shown below.
These cables and the units they connect to will be quickly destroyed by exposure to water, so use
them only in completely protected locations. Again, be sure to use only category 5 or category 5e
cables.
Crossover cable, both ends non-waterproof
Flush-mounted
units (dry)
P/N
Length
Type
Cable end 1
Cable end 2
N/A
as needed
Crossover
Non-waterproof
Non-waterproof
Non-waterproof crossover cables (purchased locally)
Standard
switch
(in dry location)
Straight-through cable,
both ends non-waterproof
P/N
Length
Type
Cable end 1
Cable end 2
N/A
as needed
Straight-through
Non-waterproof
Non-waterproof
Non-waterproof straight-through cables (purchased locally)
Summary of Contents for 6000i
