SECTION FIVE: Checking out the system
6000i
Installation Manual, Rev. G
Page 29
For more in-depth information about troubleshooting the
6000i
installation, see ”SECTION SEVEN:
Troubleshooting and servicing the 6000i system” starting on page 45.
Checking the N2 network
If N2 networking connections are used, they can be checked by turning all units on (making sure
that one has been designated as the master). Then perform the following test on any unit:
1. Press the
STAR
key several times to display the
OPTIONS/SERVICE INFO
screen.
2. Press the
MORE
menu key to display the
MORE OPTIONS / SERVICE INFO
screen.
3. Press the
N2 Status
menu key.
4. All units detected by the networking software are listed, with their model number and
serial number.
5. Check that all units are present. If any are missing from the list, check their cabling
and master slave designation. Check that the switch (if present) has power and that its
status lights are flashing for all connected units.
Summary of Contents for 6000i
