6000i
Installation Manual, Rev. G
Page 31
SECTION SIX: Interfacing the
6000i
system
This section describes the use of the NMEA, AUX, VGA and VIDEO
connections. For N2 Networking using the Ethernet connections, see
“SECTION FOUR: Networking the Northstar 6000i” beginning on page 17
A typical fully-loaded system with all options installed might be wired as follows:.
Connector
Port
Direction
Device
NMEA
NMEA 1
IN
Heading Sensor
OUT
Autopilot and other NMEA RS-422 devices
NMEA 2
IN
Radar data
OUT
Radar control
RS-232
IN
Beacon Receiver
OUT
RS-232 data copied from Port 1
HONK OUT
OUT
Remote honk, 200 ppnm or remote power
control
AUX
AUX
IN
Sounder data
OUT
Sounder control
VGA
VGA
OUT
VGA video out to computer monitor or other
640 X 480 resolution display
VIDEO
VIDEO
IN
Video in from any NTSC video source
Summary of Contents for 6000i
