Section 3 - Packaging
05/01/97 REV H
PAGE 7
Section 3 - Packaging
3.1 Housing
The sensor is housed in a rugged aluminum enclosure with a mounting
flange.
The sensor enclosure includes keyhole slots, located at the rear of the
sensors, which aid in installations of limited access. You can mount the
sensors either horizontally or vertically; see Figure 1 in Section 2, “Intro-
duction,” for case and mounting dimensions.
Northstar ships each sensor system with the following parts; check with
Northstar if these parts aren’t included with your sensor.
3.2 Northstar 8700 parts
Table 1: 8700 parts
3.3 Northstar 8800 series parts
Table 2: 8800 parts
NOTE:
The housing isn’t completely waterproof, so keep the
sensor away from direct contact with water spray or
splash.
Part #
Description
8700–A
8700 GPS position sensor
8700–PK
KS130
KS131
KS133
8700 parts kit, consisting of:
25-pin female DB–25 connector
DB–25 shielded junction shell
DB-25 short screw lock for KS131
GM630
Northstar 8700 GPS Sensor Installation Manual
Part #
Description
8800–A
8800 beacon sensor
8900–PK
KS130
KS131
KS133
8900 series parts kit, consisting of:
25-pin female DB-25 connector
DB–25 shielded junction shell
DB-25 short screw lock for KS131
8410
Optional DGPS antenna coupling unit (ACU) used
with four-foot whip antenna
Summary of Contents for 8700
