Section 9 - Connector pinouts
PAGE 40
05/01/97 REV H
9.1.5 Alternate
connector pinouts
for the 8900
An alternate configuration for the 8900 lets the BDM and GPS receivers
operate independently, whereby the GPS receiver accepts differential cor-
rections from an external device rather than the internal BDM receiver.
This is configuration 6: For this configuration, pin 23 is grounded and
pins 11 and 24 are left open. Pin connections for configuration 6 are
described below in Table 17 (functions highlighted in bold indicate the
suggested pins for a normal installation, and are the minimum connec-
tions required for operation of the 8900):
Table 17: 8900 alternate connector pinouts/config. 6
Input signals may be connected to any appropriately labeled input pin;
output signals may be taken from any appropriately labeled output pin.
7
GPS primary input 1 (RS-232)
20
BDM SC104 output (RS-232)
8
Ground
21
BDM control input 2 (RS-232)
9
BDM monitor output 3 (RS-232)
22
Not used
10
BDM monitor input 3 (RS-232)
23
Configuration pin A (leave OPEN)
11
Configuration pin B (leave OPEN)
24
Configuration pin C (leave OPEN)
12
Remote POWER ON control
25
(+) DC power input
13
(-) DC power input (Ground
—
—
Pin #
Description
Pin #
Description
Pin #
Description
Pin #
Description
1
GPS auxiliary input 2A (RS-422)
14
GPS auxiliary input 2B (RS-422)
2
Ground
15
GPS primary input 1A (RS-422)
3
GPS primary input 1B (RS-422)
16
Output 2A (Echo of input 1 - pins 7
or
15 & 3) (RS-422)
4
Output 2B (Echo of input 1 - pins 7
or
15 & 3) (RS-422)
17
Ground
5
GPS primary output 1A (RS-422)
18
GPS primary output 1B (RS-422)
6
GPS primary output 1 (RS-232)
19
Ground
7
GPS primary input 1 (RS-232)
20
BDM SC-104 output 2 (RS-232)
8
Ground
21
GPS auxiliary input 2 (RS-232)
9
BDM monitor output 3 (RS-232)
22
Not used
10
BDM monitor input 3 (RS-232)
23
Configuration pin A (to GROUND)
11
Configuration pin B (leave OPEN)
24
Configuration pin C (leave OPEN)
12
Remote POWER ON control
25
(+) DC power input
13
(-) DC power input (Ground)
—
—
Summary of Contents for 8700
