Section 10 - NMEA protocols
PAGE 50
05/01/97 REV H
Table 28: Set output configuration command
Example E:
$PMCAG,005,4.8,GGA,010,RMC,001,VTG,001,ZDA,010*48<CR><LF
Here, output messages
GGA
and
ZDA
are transmitted every 10 seconds;
RMC
and
VTG
are transmitted every second at 4800 baud.
Example F:
$PMCAG,005,1,GLL,001*2A<CR><LF>
Here,
GGL
is
transmitted every second at 4800 baud; and
GLL
is saved in
NVM.
Switch to reprogramming mode command ($PMCAG, 006)
This message switches to reprogramming mode.
Table 29: Switch to reprogramming mode command
Example G:
$PMCAG,006,19.2*7A<CR><LF>
Erase NVM command ($PMCAG, 007)
This message erases the NVM element.
Table 30: NVM command
Data field
Contents
$PMCAG,005,x.x,ccc,xxx,...,ccc,xxxx*hh<CR><LF>
x.x
Baud rate. Valid baud rates: 0.3, 0.6, 1.2, 2.4, 4.8, 9.6,
19.2, and 38.4 (in KBaud units); 0 = keep the same
baud rate (no effect), 1 = save the included list in
NVM and overwrite the previous one.
ccc,xxx
(first)
ccc,xxx
(nth)
Message block.
ccc
is the
message identifier,
xxx
is the time interval between transmissions (one
to 999 seconds; 000 will stop the transmission).
Data field
Contents
$PMCAG,006,xx.x*hh<CR><LF>
xx.x
Baud rate. Valid baud rates are 0.3, 0.6, 1.2, 2.4, 4.8,
9.6, 19.2, or 38.4 (in KBaud unit).
Data field
Contents
$PMCAG,007,xx*hh<CR><LF>
Summary of Contents for 8700
