Page 104
958 Operator’s Manual, Rev. A
Chapter 7 - Understanding the Routes Function
the parentheses indicating the waypoint is part of a saved
route and the four-digit number uniquely identifying
each waypoint).
4. Repeat these steps for each new waypoint or cursor loca-
tion you want to insert in the route.
5. When done, to change to adding waypoints to the begin-
ning or end of a route, press the
CANCEL INSERT
menu
key. To go to list-based editing, press the
RETURN
menu
key. To go back to the
CHART
screen, press the
CHART
key.
Adding waypoints to the end of a route
To add waypoints to the end of a route:
1. Move the
CURSOR PAD
to select the last waypoint in the
route.
2. Press
ADD TO END
menu key, then move the cursor to
the existing waypoint or other location that you want to
add to the end of the route. As you move the cursor, the
958 displays the new route leg as a dotted line from that
last waypoint to the cursor position.
3. If you’ve selected an existing waypoint, press the
ADD
WAYPT
menu key. If you’ve selected only a cursor posi-
tion, press the
ADD NEW WP
menu key (in this case, this
waypoint is stored with a name similar to (0001), with the
parentheses indicating the waypoint is part of a saved
Summary of Contents for 958
