Page 156
958 Operator’s Manual, Rev. A
Chapter 11 - Alarms, TideTrack, and Video Display
2. Press the
CURSOR PAD
to select
ANCHOR ALM.
3. Press the
ENTER
key.
4. Set the
ANCHOR ALARM
to
ON
if it’s currently set to
OFF
.
5. Press the
DROP ANCHOR
key.
If your vessel moves outside the anchor-alarm radius, then for
the next 10 seconds, the anchor drag icon begins flashing and
the alarm automatically beeps (you’ll hear the beeping only if
you’ve set the
ALARM AUDIO
to
ON
). The honk sequence
then starts for a total of 3.5 minutes: 1 second of honking
followed by 14 seconds of silence; 2 seconds of honking
followed by 13 seconds of silence; 3 seconds of honking
followed by 12 seconds of silence, and so forth, until the
honking is up to 14 seconds followed by 1 second of silence.
This 3.5-minute honk cycle repeats forever until you
manually clear the anchor alarm. This honk does
not
automatically clear under any conditions. To clear the alarm,
press the
STAR
key to display the
ALARMS
screen, then press
the
CLEAR ALARM
key. You may also want to set the anchor
alarm back to the
OFF
setting.
Honking for all alarms
Instead of setting all alarms to only beep, you can set all
alarms to honk. This honking starts simultaneously with any
flashing alarm icons. After you set all alarms to honk, an
alarm causes the 958 to emit a sound for half a second,
followed by silence for half a second. This honking sequence
stops when the alarms either automatically clear or you
manually clear them.
To set all alarms to honk:
1. Press the
CURSOR PAD
to highlight
HONK OUTPUT
, then
press the
EDIT ALARM
menu key.
2. Press the
CURSOR PAD
to select
ALL ALARMS
, then press
the
ENTER
key.
3. Set the
ALARM AUDIO
to
ON
if it’s currently off.
Summary of Contents for 958
