Chapter 11 - Alarms, TideTrack, and Video Display
958 Operator’s Manual, Rev. A
Page 157
Table 7 below describes how to set the anchor alarm and all
other alarms to the desired audio.
Table 7: Beep and honk settings for all alarms
Sound
Type
Setting(s)
Description
Beep
All alarms
Set
ALARM AUDIO
to
ON
The 958’s standard alarm beep.
Beep
Anchor alarm
Set
ALARM AUDIO
to
ON
Set
ANCHOR ALARM
to
ON
The 958’s standard alarm beep.
Honk
All alarms
Set
ALARM AUDIO
to
ON
Set
HONK OUTPUT
to
ALL
ALARMS
Alarm icons flash; the 958 simulta-
neously emits an output sound for half a
second, followed by silence for half a
second until the alarm is manually
cleared.
Honk
Anchor alarm
Set
ANCHOR ALARM
to
ON
Set
HONK OUTPUT
to
ANCHOR ALM
The alarm icon flashes, and the alarm
beeps (if the alarm audio is on), then
after 10 seconds the honk sequence
starts.
Summary of Contents for 958
