Chapter 1 - Getting Started
958 Operator’s Manual, Rev. A
Page 15
To move your vessel to a simulated position, press the
CURSOR PAD
to move the cursor to the desired position and
press the
DEMO POSITION
key. To start demo mode at this
new position, press the
ENTER
key. Your vessel symbol will
now be stationary at this position.
To travel from here to a new cursor location, press the
CURSOR PAD
to move the cursor to the desired position, then
press the
DEMO COG/SOG
key. To set your vessel’s speed, use
the
KEYPAD
to enter the desired speed, then press the
ENTER
key to start going to the demo cursor location.
To go back to the
CHART
screen (but stay in demo mode),
press the
RETURN
key twice. The word
DEMO
always appears
on the
CHART
screen when you’re in demo mode.
To exit demo mode, on the
DEMO
CHART
screen, press the
EXIT DEMO
key. This immediately returns you to the
CHART
screen.
NOTE:
Video image display, simulated radar image, chart rotation, and zooming
in and out all work normally on the
DEMO CHART
screen.
Summary of Contents for 958
