To show the Fuel display, press
DISP
and select
Other
Tab, select
Fuel
and press
ENT.
There are no options.
(See section 3-3 Setup > Fuel for information
about setting up the fuel values. If the number
of engines is set to
0
, the fuel features are turned
off.)
Used
shows total fuel used since this was last
reset with the
Clear Used
command.
Remaining
shows the amount of fuel
remaining in the tank(s).
Flow
shows the fuel consumption per hour.
For twin engine installations, the fuel flow for
each engine is shown separately. This is useful
for checking that both engines are under the
same load.
5-7 Fuel display
(443df only)
Fish recognition
The echo strengths shown on the A-scope can
be useful in recognising the type of fish. Different
species of fish have different sizes and shapes
of swim bladders. The air in the swim bladder
reflects the ultrasonic pulse, so the strength of
the echo varies between fish species according to
the size and shape of the swim bladder.
When fishing among a school of fish and
catching them, note the fish species and the
strength of the echo that it returns on the
A-scope. Then, when that particular echo is seen
at future times on the fishfinder, it is likely to be
the same fish species.
5-6 A-Scope perspective view
The strength of echoes on this view are
determined by the ’height’ of the echo shown on
the screen.
Northstar
Explorer 443d/443df
Installation and Operation Manual
27
Summary of Contents for EXPLORER 443D
Page 1: ...www northstarnav com Explorer 443d 443df Fishfinder Installation and Operation Manual ...
Page 2: ......
Page 39: ......
