3
Machine Component Identification
1.) Engine Control
- Location of choke, engine
speed and fuel valve.
2.) Engine -
Engine is NOT shipped with oil. Refer
to engine owners’ manual for proper viscosity and
capacity of oil for your engine.
3.) On/Off/Start Switch
- Make sure switch is at
“ON” position when starting engine with the recoil.
4.) Lifting Eyes
- Also use as tie down locations.
5.) Ball Valve
-
3/4” NPT.
6.) Pressure Gauge -
Easy to read liquid filled
gauge.
7.) Air Receiver -
30 gallon ASME certified tank.
8.) Discharge Tube
- This tube carries
compressed air from the pump to the check valve.
This tube becomes very hot during use. To avoid
the risk of severe burns, never touch the discharge
tube.
9.) Drain Valve -
Location of tank drain valve.
Drain tank daily after each use.
10.) ASME Safety Valve
- This valve automatically
releases air if the tank pressure exceeds the preset
maximum.
11
.)
Unloader
- Lift knob to relieve pressure when
starting the engine.
12.) Air Compressor Pump -
Air compressor
pump is shipped with oil. Remove shipping plug
and replace with oil fill plug in manual bag.
13.) Belt Guard
- Covers the belt, motor pulley and
flywheel.
NEVER
operate compressor without belt
guard.
14.) Compressor Air Filter -
Make sure your air
filter is clean and particle free. See pump exploded
view for replacement filter part number.
01044
2
3
14
13
4
5
11
6
10
8
1
9
7
12
