1.
During Standby mode, press MENU button on the base unit;
2.
Press DOWN button until
“
DEREGISTRATION
”
option is pointed by the pointer;
3.
Press MENU button;
4.
Press UP or DOWN button to select the target deregistration handset you desire;
5.
Press MENU button to select deregistration option;
6.
Press MENU button again to confirm;
7.
When deregistration is completed, handset will show
“
REGISTER HANDSET?
”
TONE/PULSE
(applicable to base unit only)
This telephone allows you to dial digits using the tone signaling mode or the old pulse
signaling mode.
1.
During Standby mode, press MENU button on the base unit;
2.
Press DOWN button until
“
TONE/PULSE
”
option is pointed by the pointer;
3.
Press MENU button;
4.
Press UP or DOWN button to select the dial signaling mode you desire (Tone is the
preset mode);
5.
Press MENU button to save the setting;
6.
Press BACK button to go back to Standby mode.
EDIT USERNAME
(applicable to handset only)
This telephone allows you to input your username which to be displayed during Standby
mode and paging.
1.
During Standby mode, press MENU button;
2.
Press DOWN button until
“
EDIT USERNAME
”
option is pointed by the pointer;
3.
Press MENU button;
4.
Press numeric keypad to enter username by multi-tap input (max. 15characters);
5.
Press MENU button to save the input;
6.
Press BACK button to go back to Standby mode.
NOTE:
for the operation of multi-tap input, please refer to Telephone Keypad Characters
section for more detail.
TAD RING COUNT
(applicable to base unit only)
This TAD offers each line 3 ring count options for user to select, they are 3 rings, 5 rings, TS
(TOLL SAVE).
1.
During Standby mode, press MENU button on the base unit;
2.
Press DOWN button until
“
TAD RING COUNT
”
option is pointed by the pointer;
3.
Press MENU button;
4.
Press UP or DOWN button to select your desired line1 no. of rings to answer call by
TAD (TOLL SAVE is the preset option);
5.
Press MENU button to advance to line2 setting;
6.
Press UP or DOWN button to select your desired line2 no. of rings to answer call by
TAD (TOLL SAVE is the preset option);
5.
Press MENU button to save the setting;
6.
Press BACK button to go back to Standby mode.
NOTE:
When TOLL SAVE option is selected, the TAD will answer the call after 3 rings if
there is new message(s) stored while it will answer the call after 5 rings if there is no new
message stored.
TAD DAY/TIME
(applicable to base unit only)
This TAD allows you to set the day and time running in the unit and this information is
stamp to the voice message recorded.
1.
During Standby mode, press MENU button on the base unit;
2.
Press DOWN button until
“
TAD DAY/TIME
”
option is pointed by the pointer;
14
