3.
Press MENU to confirm editing in the current location.
4.
Use the TELEPHONE KEYPAD buttons (0-9) to enter the name by multi-tap input.
You can store up to 15 characters.
5.
Press MENU button once.
6.
Enter the telephone number using the TELEPHONE KEYPAD buttons (0-9). You can
store up to 24 digits.
7.
Press MENU button to save into current memory location and goes back to Standby
mode.
NOTE:
The above procedure will overwrite current location if it is not empty. If no active
buttons are pressed for 60 seconds, the LCD display will automatically return to Standby
mode.
NOTE:
for the operation of multi-tap input, please refer to Telephone Keypad Characters
section for more detail.
VIEWING THE PHONEBOOK
On the base unit there is 20 memories Phonebook while on the handset there is 30 memories
phonebook, each record stores 15character names and 24digits number, it is a location
dependent phonebook and you can scroll through the list by arrow buttons.
1.
Press the MEM button.
2.
Press the UP or DOWN button to find the one you need, If number is more than 1
page, it will show 2 pages alternatively.
NOTE:
To exit the Phonebook at anytime, press the BACK button.
EDITING NAME AND NUMBER IN THE PHONEBOOK
1.
Press the MEM button.
2.
Press the UP or DOWN button to find the one you want to edit.
3.
Press MENU button to edit the name.
4.
Use DEL button to erase existing characters one by one and use the TELEPHONE
KEYPAD buttons (0-9) to re-enter the name by multi-tap input. (up to 15 characters)
5.
Press the MENU button once.
6.
Use DEL button to erase existing digits one by one and use the TELEPHONE KEYPAD
buttons (0-9) to re-enter the number. (up to 24 digits)
7.
Press the MENU button to confirm and save the change.
IMPORTANT:
It is not advisable to save a telephone number without the corresponding
name in the Phonebook.
NOTE:
When no active buttons are pressed for 60 seconds, the LCD display will automatically
return to Standby mode.
PLACING CALLS FROM THE PHONEBOOK
1.
Press the MEM button.
2.
Press the UP or DOWN button to find the one you want to call.
3.
Press the L1 or L2 button on handset (or L1/L2 button for base unit case) to dial out
the telephone number.
4.
Start your conversation when call is connected.
5.
To end your conversation, either press the corresponding L1 or L2 button on handset
or place the handset on the base unit (or press the corresponding L1 or L2 button for
base unit case).
NOTE:
Be sure to check that the line is not being in use by another parallel phone.
DELETING A STORED NUMBER IN THE PHONEBOOK
1.
Press the MEM button.
20
