BASE UMT CONTROLS:
Base Unit Charge Terminals - Used for charging handset batteries. We recommend that you clean these
contacts periodically with an alcohol-moistened cloth or cotton swab.
IN USE LED Indicator/ CHARGE LED Indicator /Visual Ringer LED Indicator - (IN USE LED
IndicatorjLights up steadily when the phone is in talk mode and turns off when the handset is not in use.
Will flash when paging the handset. (CHARGE LED Indicator) Lights up steadily when the handset is
being charged on the base and turns off when the handset is removed from its cradle. (Visual Ringer
LED Indicator) Flashes to indicate the phone is ringing, as a signal to the user, when the ringer is
switched off.
PAGE Button - Allows you to locate the handset when it is not on the base, or to alert the person near the
handset.
DC 6V jack - A jack located on the rear side of the base unit used for connecting the AC adaptor to the
base unit.
LINE jack - Accepts line cord to make connection with modular type telephone outlet.
INSTALLATION
CAUTION: USE ONLY THE NICKEL CADMIUM(Ni-Cd) BATTERY TYPE INCLUDED
WITH THIS UNIT. USE OF OTHER BATTERY TYPES MAY CAUSE INJURIES OR DAMAGE.
1. Remove the battery compartment cover of the handset by pressing the top of the cover and sliding it
down.
2. Connect the Ni-Cd battery pack plug along the slot into the handset's battery connector as shown
below.
Black
Wire
Battery
Connector
(Figure 1)
3. Insert the Ni-Cd battery into the battery compartment.
4. Replace the battery compartment cover by sliding it up towards the handset.
NOTE: Use the type and size of Ni-Cd battery pack. 3.6V. 600mAh. It is recommended that the Ni-Cd
battery pack should be fully charged overnight prior to initial use.
Handsel
Battery
Compartment
041505A-1
7
